Nissan Sentra Service Manual: Ipdm-e branch line circuit
Diagnosis Procedure
1.Check connector
- Turn the ignition switch off.
- Disconnect the battery cable from the negative terminal.
- Check the terminals and connectors of the ipdm e/r for damage, bend and loose connection (unit side and connector side).
Is the inspection result normal? Yes >> go to 2.
No >> repair the terminal and connector.
2.Check harness for open circuit
- Disconnect the connector of ipdm e/r.
- Check the resistance between the ipdm e/r harness connector terminals.
Is the measurement value within the specification? Yes >> go to 3.
No >> repair the ipdm e/r branch line.
3.Check power supply and ground circuit
Check the power supply and the ground circuit of the ipdm e/r. Refer to the following.
- With intelligent key system: refer to bcs-67, "diagnosis procedure".
- Without intelligent key system: refer to bcs-120, "diagnosis procedure".
Is the inspection result normal? Yes (present error)>>replace the ipdm e/r. Refer to the following
- With intelligent key system: refer to bcs-73, "removal and installation".
- Without intelligent key system: refer to bcs-126, "removal and installation".
Yes (past error)>>error was detected in the ipdm e/r branch line.
No >> repair the power supply and the ground circuit.
Abs branch line circuit
Diagnosis procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the ABS actuator and electri ...
Tcm branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and ...
Other materials:
Front wiper motor hi circuit
Component function check
1. Check front wiper hi operation
Ipdm e/r auto active test
Start ipdm e/r auto active test. Refer to ww-15, "diagnosis description"
(with intelligent key system) or
ww-19, "diagnosis description" (without intelligent key system).
Check tha ...
C1111 PUMP MOTOR
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1111
PUMP MOTOR
When a malfunction is detected in motor or motor
relay.
When a low pressure malfunction is detected in accumulator.
When a malfunction ...
Instrument lower panel lH
Removal and Installation
REMOVAL
Remove the instrument side finisher LH (1) using a suitable tool.
Remove the hood and fuel filler handle assembly from the instrument
lower panel LH. Refer to DLK-191,
"FUEL FILLER OPENER CABLE : Removal and Installation".
Release the ...
