Toyota Camry (XV70): Intuitive parking assist
The distance from your vehicle to nearby objects when parallel parking or maneuvering into a garage is measured by the sensors and communicated via the multi-information display and a buzzer. Always check the surrounding area when using this system.
Types of sensors
- Front corner sensors
- Front center sensors
- Rear corner sensors
- Rear center sensors
Turning the intuitive parking assist on/off
1. Press 
of the meter control
switches, select 
.
2. Press 
of the meter control
switches, select 
.
3. Press 
of the meter control
switch.
When the intuitive parking assist function is disabled, the intuitive parking assist OFF indicator illuminates.
To re-enable the system, select 
on
the multi-information display, select
and turn it on.
If the system is disabled, it will remain off even if the engine switch is turned to IGNITION ON mode after the engine switch has been turned off.
READ NEXT:
Display - Intuitive parking assist
When the sensors detect an object, the following displays inform the
driver of the position and distance to the object.
Front corner sensor operation
Front center sensor operation
Rear corner
Changing the buzzer sounds volume - Intuitive parking assist
The buzzer volume can be changed on the multi-information display when the
engine switch is in IGNITION ON mode.
■The system can be operated when
The engine switch is in IGNITION ON mode.
I
RCTA (Rear Cross Traffic
Alert)
The RCTA function uses the BSM rear side radar sensors
installed behind the rear bumper. This function is intended to
assist the driver in checking areas that are not easily visible
when backing up
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT
NOTICE:
Immediately after installing the front disc brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
After replacing the front disc brake pads, the brake pedal ma
Touch Panel Switch does not Function
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
When replacing the radio and display
