Additional service when replacing control unit
Additional service when replacing control unit : description
Memory reset procedure
Note:
Do not disconnect the electronic power while the moonroof is operating or within 5 seconds after the moonroof stops. (to wipe-out the memory of lid position and operating friction.)
Additional service when replacing control unit : special repair requirement
Initialization procedure
If the moonroof does not open or close automatically, use the following procedure to return moonroof operation to normal.
Note:
If the moonroof switch is released at any time during step 4, the procedure must be started over again. Leave the ignition switch ON for at least 2 seconds after this procedure.
Anti-pinch function
Caution:
General maintenance
During the normal day-to-day operation of the
vehicle, general maintenance should be performed
regularly as prescribed in this section. If
you detect any unusual sounds, vibrations or
smells, be sure to check for the cause or have a
NISSAN dealer do it promptly. In addition, you
should notify ...
P0643 Sensor power supply
Description
ECM supplies a voltage of 5.0 V to some of the sensors systematically divided
into 2 groups, respectively.
Accordingly, when a short circuit develops in a sensor power source, a
malfunction may occur simultaneously
in the sensors belonging to the same group as the shorted-circui ...
Power supply and ground circuit
Av control unit
Av control unit : diagnosis procedure
Regarding Wiring Diagram information, refer to AV-234, "Wiring Diagram".
1.Check fuse
Check that the following fuses are not blown.
Are the fuses blown?
Yes >> replace the blown fuse after repairing the affected circuit.
...