Nissan Sentra Service Manual: Illumination control switch
Removal and installation
Removal
- Remove instrument finisher d. Refer to ip-14, "exploded view".
- Remove the illumination control switch (1) from the switch carrier (2) using suitable tool (a).
: Pawl
Installation
Installation is in the reverse order of removal.
Trunk room lamp
Removal and Installation
Warning:
Do not touch bulb while it is lit or right after being turned off.
Burning may result.
Caution:
Do not touch glass surface of the bulb with bare hands or allow ...
Service data and specifications (SDS)
Bulb Specifications
*: Always check with the parts department for the latest parts information. ...
Other materials:
Checking engine coolant level
Check the coolant level in the reservoir when
the engine is cold. If the coolant level is below
the MIN level B , add coolant to the MAX level
A . If the reservoir is empty, check the coolant
level in the radiator when the engine is cold. If
there is insufficient coolant in the radiator, fi ...
Troubleshooting guide
The system should respond correctly to all voice
commands without difficulty. If problems are encountered,
try the following solutions.
Where the solutions are listed by number, try
each solution in turn, starting with number 1, until
the problem is resolved.
Symptom
Solution
...
Operating tips
CAUTION
Do not use alcohol, benzine or thinner
to clean the camera. This will cause
discoloration. To clean the camera,
wipe with a cloth dampened with a diluted
mild cleaning agent and then wipe
with a dry cloth.
Do not damage the camera as the monitor
screen may be adversely affe ...
