Diagnosis procedure
1.Check connector
Is the inspection result normal? Yes >> go to 2.
No >> repair the terminal and connector.
2.Check harness for open circuit
Is the measurement value within the specification? Yes >> go to 3.
No >> repair the a/c auto amp. Branch line.
3.Check power supply and ground circuit
Check the power supply and the ground circuit of the a/c auto amp. Refer to hac-83, "a/c auto amp. : Diagnosis procedure".
Is the inspection result normal? Yes (present error)>>replace the a/c auto amp. Refer to hac-105, "removal and installation".
Yes (past error)>>error was detected in the a/c auto amp. Branch line.
No >> repair the power supply and the ground circuit.
Changing shift ranges in S mode
When the shift lever is in the S position, the shift lever or paddle shift
switches (if equipped) can be operated as follows:
Shift lever
Paddle shift switches (if
equipped)
Upshifting
Downshifting
The initial shift range in S mode is set automatically to 4, 5 or 6
according to veh ...
P0607 ECM
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0607
ECM
(Control module performance)
ECM internal communication system is malfunctioning.
ECM
DTC CONFIRMATION PROCEDURE
1. ...
Rear window defogger feedback signal
Description
Turns the indicator lamp in the rear window defogger switch ON when operating
the rear window defogger.
Component function check
1.Check rear window defogger feedback signal
Check that the indicator lamp of rear window defogger switch is illuminated
when turning the rear window
...