Nissan Sentra Owners Manual: Headlights

Nissan Sentra Owners Manual / Maintenance and do-it-yourself / Lights / Headlights

Replacing the halogen headlight bulb

The headlight is a semi-sealed beam type which uses a replaceable headlight (halogen) bulb. Because the headlight assembly must be removed from the vehicle for bulb replacement, see your NISSAN dealer.

CAUTION

Aiming is not necessary after replacing the bulb. When aiming adjustment is necessary, contact a NISSAN dealer.
Do not leave the headlight assembly open without a bulb installed for a long period of time. Dust, moisture, smoke, etc. entering the headlight body may affect bulb performance. Remove the bulb from the headlight assembly just before a replacement bulb is installed.
Only touch the base when handling the bulb. Never touch the glass envelope.
Touching the glass could significantly affect bulb life and/or headlight performance.
High pressure halogen gas is sealed inside the halogen bulb. The bulb may break if the glass envelope is scratched or the bulb is dropped.
Use the same number and wattage as shown in the chart.

Fog may temporarily form inside the lens of the exterior lights in the rain or in a car wash. A temperature difference between the inside and the outside of the lens causes the fog. This is not a malfunction. If large drops of water collect inside the lens, contact a NISSAN dealer.

Lights

...

Fog lights (if so equipped)

Replacing the fog light bulb Disconnect the negative battery cable. Remove the fasteners A ; carefully pull back the front fender protector . Rotate the bulb B counterclockwise and pul ...

Other materials:

Vin registration
Description VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced. NOTE: Accurate VIN which is registered in ECM may be required for Inspection & Maintenance (I/M). Work Procedure 1.CHECK VIN Check the VIN of the vehicle and note it. ...

SRS Air bag warning lamp does not turn OFF
Diagnosis Procedure 1.CHECK AIR BAG MODULE AND SEAT BELT PRE-TENSIONER Check the deployment of air bag module. Is air bag module deployed? YES >> Replace the malfunctioning parts. NO >> GO TO 2. 2.CHECK AIR BAG FUSE Check 10 A fuse [No.3, located in fuse block (J/B)]. Is th ...

U1010 Control unit (CAN)
Description Air bag diagnosis sensor performs self-tests on key ON. If CAN communication failure within control unit is detected, DTC is set. DTC Logic DTC DETECTION LOGIC CONSULT name DTC DTC detecting condition Repair order CAN CONTROL UNIT FAILURE U1010 CAN ...