Nissan Sentra Service Manual: Glove box lamp
Removal and installation
Warning:
Do not touch bulb while it is lit or right after being turned off. Burning may result.
Caution:
Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
Removal
- Remove the glove box assembly. Refer to ip-22, "removal and installation".
- Rotate the glove box lamp socket assembly counterclockwise and remove.
- Remove the glove box lamp housing.
Installation
- Install the glove box lamp housing.
- Insert bulb socket into glove box lamp housing and rotate clockwise to lock in position.
- Install glove box assembly. Refer to ip-22, "removal and installation".
Bulb replacement
The glove box lamp bulb is serviced as part of the glove box lamp socket. Refer to inl-54, "removal and installation".
Vanity mirror lamp
Removal and installation
Caution:
Do not attempt to separate the vanity mirror lamp from the sun visor or
damage to the components
may occur.
Note:
The vanity mirror lamp is replaced as part o ...
Interior room lamp
Removal and installation
Removal
Insert a suitable tool into the gap between the headlining and the
interior room lamp and release the interior
room lamp.
Disconnect the harness connector ...
Other materials:
Battery current sensor
Exploded view
Battery current sensor
Current sensor harness connector
Removal and installation
Removal
Loosen the battery terminal nut and disconnect battery negative
terminal. Refer to PG-50, "Exploded
View".
Disconnect the harness connector from current sensor.
...
Bluetooth® settings
To access and adjust the settings for the
Bluetooth® Hands-Free Phone System:
Press the SETTING button.
Use the TUNE/SCROLL knob to select
“Bluetooth” and then press the ENTER button:
Bluetooth
Select “On” or “Off” to turn the vehicle’s
Bluetooth® system on or ...
Engine maintenance
Drive belt
Drive belt : inspection
Alternator
Drive belt auto-tensioner
Crankshaft pulley
A/c compressor
Water pump
Drive belt
Possible use range
New drive belt range
Ndicator
Warning:
Perform this step when engine is stopped.
Check that the indicator of drive bel ...
