Nissan Sentra manuals

Nissan Sentra Service Manual: Front wiper motor hi circuit

Nissan Sentra Service Manual / Driver controls / Wiper & washer / Dtc/circuit diagnosis / Front wiper motor hi circuit

Component function check

1. Check front wiper hi operation

Ipdm e/r auto active test


  1. Start ipdm e/r auto active test. Refer to ww-15, "diagnosis description" (with intelligent key system) or ww-19, "diagnosis description" (without intelligent key system).
  2. Check that the front wiper operates at the hi operation.

Consult active test


  1. Select front wiper of ipdm e/r active test item.
  2. While operating the test item, check that front wiper hi operation and off.

Hi : front wiper hi operation

Off : stop the front wiper.

Is the inspection result normal? Yes >> the front wiper motor hi circuit is normal.

No >> refer to ww-39, "diagnosis procedure".

Diagnosis procedure

Regarding wiring diagram information, refer to ww-24, "wiring diagram - with intelligent key" or ww-29, "wiring diagram - without intelligent key".

1. Check front wiper motor (hi) input voltage

Consult active test


  1. Turn the ignition switch off.
  2. Disconnect front wiper motor.
  3. Turn the ignition switch on.
  4. Select front wiper of ipdm e/r active test item.
  5. While operating the test item, check voltage between ipdm e/r harness connector e45 and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 2.

NO >> Replace IPDM E/R. Refer to PCS-30, "Removal and Installation" (with Intelligent Key system) or PCS-58, "Removal and Installation" (without Intelligent Key system).

2. Check front wiper motor (hi) open circuit

  1. Turn the ignition switch off.
  2. Disconnect ipdm e/r.
  3. Check continuity between ipdm e/r harness connector e45 and front wiper motor harness connector e1.

Is the inspection result normal?


Is the inspection result normal?

Yes >> go to 3.

No >> repair or replace the harness or connectors.

3. Check front wiper motor (hi) short circuit

Check continuity between ipdm e/r harness connector e45 and ground.

Is the inspection result normal?


Is the inspection result normal? Yes >> repair or replace the harness or connectors.

No >> replace front wiper motor. Refer to ww-62, "removal and installation".

Front wiper motor lo circuit
Component function check 1. Check front wiper lo operation Ipdm e/r auto active test Start ipdm e/r auto active test. Refer to pcs-9, "diagnosis description" (with intelligent key ...

Front wiper auto stop signal circuit
Component function check 1. Check front wiper (auto stop) operation Consult data monitor Select “WIP AUTO STOP” of IPDM E/R DATA MONITOR item. Operate the front wiper. With the fr ...

Other materials:

Sun visors
To block glare from the front, swing down the sun visor. To block glare from the side, remove the sun visor from the center mount and swing the visor to the side. Slide the extension sun visor in or out as needed. CAUTION Do not store the sun visor before returning the exte ...

Roof side molding
Exploded view Roof side molding Roof side molding clip Roof panel Body side outer panel Adhesive tape Removal and installation REMOVAL ROOF SIDE MOLDING Release roof side molding rear side clip, using a suitable tool (A). Clip Front CAUTION: Apply protective tape ...

Daytime light relay circuit
Description The bcm sends a daytime light request to the ipdm e/r via the can communication lines. The power flows through fuse 29 located in fuse block j/b to the daytime light relay coil. When the ipdm e/r operates the daytime light relay, power is sent to the daytime lamps. Diagnosis proc ...

© 2014-2024 Copyright www.nisentra.com