Nissan Sentra Service Manual: Front fog lamp
Removal and Installation
FOG LAMP
Removal
- Position the fender protector aside. Refer to EXT-28, "FENDER PROTECTOR : Removal and Installation - Front Fender Protector".
- Disconnect the harness connector from the front fog lamp.
- Remove the screws and the front fog lamp.
Installation
Installation is in the reverse order of removal.
NOTE:
After installing, perform fog lamp aiming adjustment. Refer to EXL-117, "Aiming Adjustment".
FRONT FOG LAMP BULB
Removal
WARNING:
Do not touch bulb by hand while it is lit or right after being turned off. Burning may result.
CAUTION:
- Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
- Do not leave the bulb out of the lamp reflector for a long time
because dust, moisture, smoke, etc.
may affect the performance of the lamp.
- Position the front fender protector aside. Refer to EXT-28, "FENDER PROTECTOR : Removal and Installation - Front Fender Protector".
- Disconnect the harness connector from the front fog lamp bulb.
- Rotate the front fog lamp bulb socket counterclockwise and remove.
Installation
Installation is in the reverse order of removal.
CAUTION:
After installing, be sure to install the bulb socket securely to ensure watertightness.
Revision:
Front combination lamp
Exploded view
Large cover (not serviceable)
Small cover (not serviceable)
Front combination lamp
Halogen lamp bulb (high beam)
Turn signal lamp bulb
Turn signal lamp bulb socket
...
Door mirror turn signal lamp
Removal and installation
The door mirror side turn signal lamp is integrated into the door mirror
assembly and is serviced as an assembly.
Refer to MIR-18, "Exploded View". ...
Other materials:
General maintenance
During the normal day-to-day operation of the
vehicle, general maintenance should be performed
regularly as prescribed in this section. If
you detect any unusual sounds, vibrations or
smells, be sure to check for the cause or have a
NISSAN dealer do it promptly. In addition, you
should notify ...
Both side headlamps (lo) are not
turned on
Description
The headlamps (both sides) do not turn on in any lighting switch setting.
Diagnosis Procedure
1.Check combination switch (lighting and turn signal switch)
Check the combination switch (lighting and turn signal switch). Refer to
BCS-72, "Symptom Table" (with Intelligent
...
Ecu diagnosis information
Av control unit
Reference value
TERMINAL LAYOUT
PHYSICAL VALUES
Dtc index
Bose speaker amp
Reference value
TERMINAL LAYOUT
PHYSICAL VALUES
...
