Nissan Sentra manuals

Nissan Sentra Service Manual: Front drive shaft boot

Nissan Sentra Service Manual / Transmission & driveline / Front axle / Removal and installation / Front drive shaft boot

Exploded View

(LH)
(LH)

  1. Circular clip
  2. Dust shield
  3. Slide joint housing
  4. Snap ring
  5. Spider assembly
  6. Boot band
  7. Boot
  8. Shaft
  9. Damper band
  10. Dynamic damper
  11. Circular clip
  12. Joint sub-assembly

Wheel side


(RH) 6M/T
(RH) 6M/T

  1. Joint sub-assembly
  2. Circular clip
  3. Boot band
  4. Boot
  5. Shaft
  6. Damper band
  7. Dynamic damper
  8. Boot band
  9. Boot
  10. Spider assembly
  11. Snap ring
  12. Slide joint housing
  13. Dust shield
  14. Support bearing
  15. Snap ring
  16. Dust shield

Wheel side


(RH) Except 6M/T
(RH) Except 6M/T

  1. Joint sub-assembly
  2. Circular clip
  3. Boot band
  4. Boot
  5. Shaft
  6. Damper band
  7. Dynamic damper
  8. Spider assembly
  9. Snap ring
  10. Slide joint housing
  11. Dust shield
  12. Circular clip

Wheel sideWheel side


Front wheel hub
Exploded View Steering knuckle Splash guard Wheel stud Wheel hub and bearing Disc brake rotor Wheel hub lock nut Nut retainer Cotter pin Removal and Installation Remove t ...

Wheel side
WHEEL SIDE : Removal and Installation REMOVAL Remove the wheel and tire using power tool. Refer to WT-47, "Exploded View". Remove the brake caliper torque member bolts, leaving the ...

Other materials:

C1105, C1106, C1107, C1108 Wheel sensor
Description When the sensor rotor rotates, the magnetic field changes. It converts the magnetic field changes to current signals (rectangular wave) and transmits them to the ABS actuator and electric unit (control unit). DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunct ...

Automatic speed control device (ASCD)
AUTOMATIC SPEED CONTROL DEVICE (ASCD) : System Description SYSTEM DIAGRAM BASIC ASCD SYSTEM Refer to Owner's Manual for ASCD operating instructions. Automatic Speed Control Device (ASCD) allows a driver to keep vehicle at predetermined constant speed without depressing accelerator pedal ...

Evaporative emission system
Inspection EVAP CANISTER 1.CHECK EVAP CANISTER Block port (B). Blow air into port (A) and check that it flows freely out of port (C). Release blocked port (B). Apply vacuum pressure to port (B) and check that vacuum pressure exists at the ports (A) and (C). Block port (A) and (B). ...

В© 2014-2025 Copyright www.nisentra.com