Nissan Sentra Service Manual: Electrical & power control
- Power outlet
- Body control system
- Lan system
- Can fundamental
- Can
- Can system (type 1)
- Can system (type 2)
- Can system (type 3)
- Can system (type 4)
- Can system (type 5)
- Power control system
- Charging system
- Precaution
- Preparation
- System description
- Wiring diagram
- Basic inspection
- Dtc/circuit diagnosis
- Symptom diagnosis
- Removal and installation
- Service data and specifications (SDS)
- Power supply, ground & circuit elements
Removal and installation
Horn
Exploded view
Horn high
Horn low
Front
Note:
Shown with the front fascia removed for clarity.
Removal and installation
Horn low
Removal
Remove the core support cover. Ref ...
Power outlet
...
Other materials:
Symptom diagnosis
Noise, vibration and harshness (NVH) troubleshooting
NVH troubleshooting chart
Locate the area where noise occurs.
Confirm the type of noise.
Specify the operating condition of engine.
Check specified noise source.
If necessary, repair or replace these parts.
Closely relate ...
Oil pan
Exploded View
O-ring
Oil pan (upper)
Oil level gauge guide
O-ring
Oil level gauge
Oil pump drive chain
Crankshaft sprocket
Oil pump sprocket
Oil pump chain tensioner
Oil pump
Drain plug
Drain plug washer
Oil pan (lower)
Oil filter
Clamp
Water hose
Oil cooler
...
DTC/circuit diagnosis
U1000 can comm
Description
Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description".
Dtc logic
DTC DETECTION LOGIC
NOTE:
U1000 can be set if a module harness was disconnected and reconnected,
perhaps during a repair. Confirm
that there are actual CAN diagnostic symptoms a ...
