Nissan Sentra Service Manual: Ecu diagnosis information

Nissan Sentra Service Manual / Electrical & power control / Body control system / Without intelligent key system / Ecu diagnosis information

Bcm

Reference value

NOTE:

The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

Activate and display TPMS transmitter IDs
Display tire pressure reported by the TPMS transmitter
Read TPMS DTCs
Register TPMS transmitter IDs
Test remote keyless entry keyfob relative signal strength

VALUES ON THE DIAGNOSIS TOOL

Terminal layout

Terminal layout

Physical values

Physical values

Fail-safe

Fail-safe

Fail-safe control by dtc

Bcm performs fail-safe control when any dtc are detected.

Fail-safe control of combination switch reading function caused by low

Fail-safe control of combination switch reading function caused by low power supply voltage

If voltage of battery power supply lower, BCM maintains combination switch reading to the status when input voltage is less than approximately 9 V.

Note:

When voltage of battery power supply is approximately 9 v or more, combination switch reading function returns to normal operation.

Dtc inspection priority chart

If some dtcs are displayed at the same time, perform inspections one by one based on the following priority chart.

Dtc index

Dtc index

Note:

Details of time display

Crnt: displays when there is a malfunction now or after returning to the normal condition until turning ignition switch off ƒ¸ on again.
1 - 39: Displayed if any previous malfunction is present when current condition is normal. It increases like 1 → 2 → 3...38 → 39 after returning to the normal condition whenever ignition switch OFF → ON. The counter remains at 39 even if the number of cycles exceeds it. It is counted from 1 again when turning ignition switch OFF → ON after returning to the normal condition if the malfunction is detected again.

Wiring diagram

Diagnosis system (bcm)

Common item Common item : consult function (bcm - common item) APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. Direct Diagnostic Mode Descriptio ...

Other materials:

Read first—then drive safely
FOREWORD Welcome to the growing family of new NISSAN owners. This vehicle is delivered to you with confidence. It was produced using the latest techniques and strict quality control. This manual was prepared to help you understand the operation and maintenance of your vehicle so that you ma ...

Dynamic radar cruise control
Summary of functions In vehicle-to-vehicle distance control mode, the vehicle automatically accelerates and decelerates to match the speed changes of the preceding vehicle even if the accelerator pedal is not depressed. In constant speed control mode, the vehicle runs at a fixed speed. Use the ...

Component parts
Component Parts Location IPDM E/R, (Headlamp high relay, Headlamp low relay, Taillamp relay and Front fog lamp relay (if equipped)) Stop lamp switch Parking brake switch Combination meter Combination switch (lighting and turn signal switch) BCM (view with combination meter r ...