Nissan Sentra Service Manual: Dtc/circuit diagnosis
- C1101, C1102, C1103, C1104 Wheel sensor
- C1105, C1106, C1107, C1108 Wheel sensor
- C1109 Power and ground system
- 1110, C1170 ABS Actuator and electric unit (control unit)
- C1111 PUMP MOTOR
- C1113, C1145, C1146 Yaw rate/side/decel G Sensor
- C1115 ABS Sensor [abnormal signal]
- C1116 Stop lamp switch
- C1120, C1122, C1124, C1126 ABS In valve system
- C1121, C1123, C1125, C1127 ABS OUT Valve system
- C1130 Engine signal
- C1140 Actuator relay system
- C1142 Press sensor
- C1143 Steering angle sensor
- 1144 Incomplete steering angle sensor adjustment
- C1155 BR Fluid level low
- C1164, C1165, C1166, C1167 CV/SV System
- U1000 CAN Comm circuit
- U1002 System comm (CAN)
- U1010 Control unit (CAN)
- Parking brake switch
- VDC OFF Switch
- ABS Warning lamp
- Brake warning lamp
- VDC OFF Indicator lamp
- Slip indicator lamp
Adjustment of steering angle sensor neutral position
Description
Refer to the table below to determine if adjustment of steering
angle sensor neutral position is required.
×: Required –: Not required
Work Procedure
ADJUSTMENT OF ST ...
C1101, C1102, C1103, C1104 Wheel sensor
Description
When the sensor rotor rotates, the magnetic field changes. It
converts the magnetic field changes to current
signals (rectangular wave) and transmits them to the ABS actuator and elec ...
Other materials:
Seat belt extenders
If, because of body size or driving position, it is
not possible to properly fit the lap/shoulder belt
and fasten it, an extender that is compatible with
the installed seat belts is available that can be
purchased. The extender adds approximately 8 in
(200 mm) of length and may be used for eith ...
Unbalance steering wheel turning force and return between right
and left
Description
Unbalance steering wheel turning force and return between right
and left.
Diagnosis Procedure
1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP
Check the EPS warning lamp while engine is running.
Does the EPS warning lamp turn OFF?
YES >> GO TO 2.
NO >> Refer to S ...
Installing front license plate
Use the following steps to mount the front license
plate:
Make holes on the plastic finisher at the
location mark (small dimple) using a 0.20 in
(5 mm) drill. Apply light pressure to the drill.
Install the license plate holder using the two
screws provided with the holder.
Mount ...
