Nissan Sentra Service Manual: DTC/Circuit diagnosis

ID registration procedure

Description This procedure must be performed after replacing wheels, transmitters or the BCM, or rotating wheels. Work Procedure TPMS ID registration can be performed using one of the following ...

C1704, C1705, C1706, C1707 Low tire pressure

DTC Logic NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS ...

Other materials:

Map lamp
Removal and installation Removal Lower front edge of map lamp (1) down from the headlining by releasing the metal clips, then slide forward to clear pawls at rear. : Metal clip Pawl Disconnect the harness connectors from the map lamp and remove. Installation Installation is in t ...

Od off indicator lamp
Component Function Check 1.CHECK OD OFF INDICATOR LAMP FUNCTION Check OD OFF indicator lamp turns ON for approx. 2 seconds when ignition switch turns ON. Is the inspection result normal? YES >> INSPECTION END NO >> Go to TM-239, "Diagnosis Procedure". Diagnosis Proce ...

C1105, C1106, C1107, C1108 Wheel sensor
Description When the sensor rotor rotates, the magnetic field changes. It converts the magnetic field changes to current signals (rectangular wave) and transmits them to the ABS actuator and electric unit (control unit). DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunct ...