POSITION SWITCH
BACK-UP LAMP SWITCH
BACK-UP LAMP SWITCH : Component Inspection
1.CHECK BACK-UP LAMP SWITCH


Is the inspection result normal? YES >> INSPECTION END
NO >> Replace position switch. Refer to TM-21, "Removal and Installation".
PARK/NEUTRAL POSITION (PNP) SWITCH
Park/neutral position (PNP) Switch :Component Inspection
1.CHECK PARK/NEUTRAL POSITION (PNP) SWITCH


Is the inspection result normal? YES >> INSPECTION END
NO >> Replace position switch. Refer to TM-21, "Removal and Installation".
System description
Symptom diagnosisDtc/circuit diagnosis
U1000 can comm circuit
DTC Logic
Dtc detection logic
Consult display
Dtc detection condition
Possible cause
Can comm circuit
[u1000]
Av control unit is not transmitting or receiving
can communication signal for 2 seconds or
more.
CAN communication system.
...
Strg branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the steering angle sensor for
damage, bend and loose connection
(unit side and connector side).
Is the inspection result ...
Tire Pressure Monitoring System (TPMS)
This vehicle is equipped with the Tire Pressure
Monitoring System (TPMS). It monitors tire pressure
of all tires except the spare. When the low
tire pressure warning light is lit, and the CHECK
TIRE PRES warning message is displayed in the
odometer, one or more of your tires is significantly
u ...