Nissan Sentra Owners Manual: Driving on snow or ice

Nissan Sentra Owners Manual / Starting and driving / Cold weather driving / Driving on snow or ice

WARNING

Wet ice (32°F, 0°C and freezing rain), very cold snow or ice can be slick and very hard to drive on. The vehicle will have much less traction or “grip” under these conditions. Try to avoid driving on wet ice until the road is salted or sanded.
Whatever the condition, drive with caution.
Accelerate and slow down with care. If accelerating or downshifting too fast, the drive wheels will lose even more traction.
Allow more stopping distance under these conditions. Braking should be started sooner than on dry pavement.
Allow greater following distances on slippery roads.
Watch for slippery spots (glare ice).
These may appear on an otherwise clear road in shaded areas. If a patch of ice is seen ahead, brake before reaching it. Try not to brake while on the ice, and avoid any sudden steering maneuvers.
Do not use the cruise control (if so equipped) on slippery roads.
Snow can trap dangerous exhaust gases under your vehicle. Keep snow clear of the exhaust pipe and from around your vehicle.

Special winter equipment

It is recommended that the following items be carried in the vehicle during winter: A scraper and stiff-bristled brush to remove ice and snow from the windows and wiper blades. A sturdy, fl ...

Engine block heater (if so equipped)

Engine block heaters are used to assist with cold temperature starting. The engine block heater should be used when the outside temperature is 20°F (-7°C) or lower. WARNING Do not u ...

Other materials:

Removal and installation
Combination meter Exploded view Combination meter Front cover Removal and installation Removal Remove cluster lid a. Refer to ip-19, "removal and installation". Remove the screws from the combination meter. Remove the combination meter. Disconnect the comb ...

Battery saver output/power supply circuit
Description Provides the battery saver output/power supply. Also cuts the power supply when the interior lamp battery saver is activated. Component function check 1.Check battery saver output/power supply function Consult Turn ignition switch on. Turn each interior lamp to the ON posit ...

P050A, P050B, P050E Cold start control
Description ECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition. This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P050A, P050B or P050E ...