Nissan Sentra Owners Manual: Doors

Nissan Sentra Owners Manual / Pre-driving checks and adjustments / Doors

When the doors are locked using one of the following methods, the doors cannot be opened using the inside or outside door handles. The doors must be unlocked to open the doors.

WARNING

Always have the doors locked while driving. Along with the use of seat belts, this provides greater safety in the event of an accident by helping to prevent persons from being thrown from the vehicle. This also helps keep children and others from unintentionally opening the doors, and will help keep out intruders.
Before opening any door, always look for and avoid oncoming traffic.
Do not leave children unattended inside the vehicle. They could unknowingly activate switches or controls. Unattended children could become involved in serious accidents.

NISSAN Vehicle Immobilizer System keys

You can only drive your vehicle using the master keys which are registered to the NISSAN Vehicle Immobilizer System components in your vehicle. These keys have a transponder chip in the key head ...

Locking with key

Driver’s side The power door lock system allows you to lock or unlock all doors at the same time. Turning the key toward the front 1 of the vehicle locks all doors. Turning the key one ...

Other materials:

Main line between ipdm-e and dlc circuit
Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). Harness connector E4 Harness connec ...

P2857 Clutch A Pressure
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P2857 CLUTCH A PRESSURE (Clutch A Pressure Engagement Performance) The auxiliary gearbox gear ratio is 2.232 or more for the auxili ...

Auto operation does not operate but manual operate normally (driver side)
Diagnosis Procedure 1.PERFORM INITIALIZATION PROCEDURE Initialization procedure is executed and operation is confirmed. Refer to PWC-29, "Work Procedure". Is the inspection result normal? YES >> INSPECTION END NO >> GO TO 2. 2.CHECK ENCODER CIRCUIT Check encoder cir ...