Nissan Sentra Owners Manual: Door locks/unlocks precaution

Nissan Sentra Owners Manual / Pre-driving checks and adjustments / NISSAN Intelligent Key® (if so equipped) / Door locks/unlocks precaution

Do not push the door handle request switch with the Intelligent Key held in your hand as illustrated. The close distance to the door handle will cause the Intelligent Key system to have difficulty recognizing that the Intelligent Key is outside the vehicle.
After locking with the door handle request switch, verify the doors are securely locked by testing them.
To prevent the Intelligent Key from being left inside the vehicle, make sure you carry the Intelligent Key with you and then lock the doors.
Do not pull the door handle before pushing the door handle request switch. The door will be unlocked but will not open. Release the door handle once and pull it again to open the door.

Operating range

The Intelligent Key functions can only be used when the Intelligent Key is within the specified operating range from the request switch 1. When the Intelligent Key battery is discharged or str ...

NISSAN Intelligent Key® Operation

You can lock or unlock the doors without taking the Intelligent Key out of your pocket or bag. When you carry the Intelligent Key with you, you can lock or unlock all doors by pushing the doo ...

Other materials:

Clutch disc and clutch cover
Exploded View Flywheel Clutch disc Clutch cover Input shaft First step Final step Apply lithium-based grease including molybdenum disulphide. Removal and Installation CAUTION: Do not reuse CSC (Concentric Slave Cylinder). The CSC slides back to the original posit ...

Controls
Fan control dial The fan control dial turns the fan on and off, and controls fan speed. Air flow control buttons The air flow control buttons allow you to select the air flow outlets. MAX — Air flows from center and side A/Cvents with maximum cooling. — Air flows from center and side v ...

S connector circuit
Description The starter motor magnetic switch is supplied with power when the ignition switch is turned to the START position while the selector lever is in the P (Park) or N (Neutral) position (CVT Models) or the clutch pedal is depressed (M/T Models). Diagnosis Procedure Regarding Wiring ...