Nissan Sentra Service Manual: Dlc branch line circuit

Nissan Sentra Service Manual / Electrical & power control / Lan system / Can system (type 2) / Dlc branch line circuit

Diagnosis Procedure

1.Check connector

Turn the ignition switch off.
Disconnect the battery cable from the negative terminal
Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side).

Is the inspection result normal? Yes >> go to 2.

No >> repair the terminal and connector.

2.Check harness for open circuit

Check the resistance between the data link connector terminals.

Is the measurement value within the specification?

Is the measurement value within the specification? YES (Present error)>>Check CAN system type decision again.

YES (Past error)>>Error was detected in the data link connector branch line circuit.

NO >> Repair the data link connector branch line.

A-bag branch line circuit

Diagnosis procedure Warning: Always observe the following items for preventing accidental activation. Before servicing, turn ignition switch off, disconnect battery negative terminal, and w ...

Eps branch line circuit

Diagnosis Procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the eps control unit for dam ...

Other materials:

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as вЂњAIR BAGвЂќ and вЂњSEAT BELT PRE-TENSIONERвЂќ, used along with a front seat belt, helps to reduce the risk or severity of injur ...

Precaution for Brake Control System
Always perform a pre-driving check to drive the vehicle. Always check speed and safety while driving the vehicle. To operate CONSULT while driving, more than one person is required to be in the vehicle to avoid interference to driving and ensure safety. Slight vibrations ar ...

C1704, C1705, C1706, C1707 Low tire pressure
DTC Logic NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS transmitter IDs Display tire pressure reported by the TPMS transmitter Read TPMS DTCs Register ...