Nissan Sentra Service Manual: Disassembly and assembly
FUEL LEVEL SENSOR UNIT
Exploded View
Fuel Level Sensor Unit
- Fuel filter and pump assembly
- Fuel level sensor unit
- Float arm assembly
- Fuel tank temperature sensor
- Fuel level sensor unit/fuel tank temperature sensor harness connector
Disassembly and Assembly
DISASSEMBLY
- Disconnect fuel level sensor unit/fuel tank temperature sensor
harness connector (1).
NOTE:
Hold connector with your fingers, because there is no tab for
releasing stopper. Pull it out straight downward.
- Remove fuel tank temperature sensor (2) from fuel filter and fuel
pump assembly (1).
- Using a suitable tool (2), remove fuel level sensor unit (3) from
fuel filter and fuel pump assembly (1).
CAUTION:
- Be careful not to damage the fuel level sensor unit.
- Do not disassemble fuel filter and fuel pump assembly.
ASSEMBLY
- Check for damage of fuel level sensor unit installation position on the
side of fuel filter and pump assembly.
- Slide fuel level sensor unit until it aligns to installation groove,
then insert it until it stops.
- After inserting, apply force in reverse direction (removal direction) to
ensure it cannot be pulled out.
- Connect fuel level sensor unit/fuel tank temperature sensor harness
connector.
INSPECTION AFTER INSTALLATION
Use the following procedure to check for fuel leaks.
- Turn ignition switch “ON” (with engine stopped), then check connections
for leaks by applying fuel pressure
to fuel piping.
- Start engine and let it idle and check there are no fuel leaks at the
fuel system connections.
Exploded View
EVAP canister bracket
EVAP canister filter drain hose
EVAP canister filter
EVAP canister protector
EVAP hose
EVAP canister vent control valve
O-ring
EVAP canister
...
Fuel Tank
Standard and Limit
Standard and Limit
...
Other materials:
Reporting safety defects
for U.S. owners
If you believe that your vehicle has a defect which could cause a
crash or could cause injury or death, you should immediately inform
the National Highway Traffic Safety Administration (NHTSA) in addition
to notifying Toyota Motor Sales, U.S.A., Inc. (Toll-free: 1-800-
331-4331).
If NHTSA recei ...
Changing engine oil filter
Park the vehicle on a level surface and apply
the parking brake.
Turn the engine off.
Place a large drain pan under the oil filter C .
Loosen the oil filter with an oil filter wrench
by turning it counterclockwise. Then remove
the oil filter by turning it by hand.
CAUTION
Be c ...
Low tire pressure warning lamp does not turn on
Low Tire pessure Warning Lamp Does Not Come On When Ignition Switch Is
Turned On
Note:
The Signal Tech II Tool (J-50190) can be used to perform the following
functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and display TPMS transmitter IDs
Display t ...
© 2014-2024 Copyright www.nisentra.com