Description
The daytime light system is inoperative even though the combination switch (lighting and turn signal switch) and parking brake switch are in the normal setting, also whenever engine is operating.
Diagnosis procedure
1.Check daytime light operation
Is the inspection results normal? Yes >> replace bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs- 126, "removal and installation" (without intelligent key system).
No >> go to 2.
2.Check daytime light relay fuse

Is the fuse blown? YES >> Replace the blown fuse after repairing the affected circuit.
NO >> GO TO 3.
3.Check daytime light bulbs
Check the daytime light bulbs are not open.
Is the inspection result normal? Yes >> go to 4.
No >> replace the bulbs.
4.Perform daytime light circuit inspection
Check the daytime light circuit. Refer to exl-92, "diagnosis procedure".
Is the inspection results normal? Yes >> replace ipdm e/r. Refer to pcs-30, "removal and installation" (with intelligent key system) or pcs-58, "removal and installation" (without intelligent key system).
No >> repair or replace the malfunctioning part.
Both side headlamps do not switch
to high beam
Both side headlamps (lo) are not
turned onService data and specifications (SDS)
Wheel Alignment (Unladen*1)
UNITED STATES and CANADA
*1: Fuel, engine coolant, and lubricants are full. Spare tire, jack, hand
tools, and mats are in designated positions.
*2: The difference when assuming the (LH) side is the standard.
Ball Joint
Wheelarch Height (Unladen*)
UNITED S ...
C1101, C1102, C1103, C1104 Wheel sensor
Description
When the sensor rotor rotates, the magnetic field changes. It
converts the magnetic field changes to current
signals (rectangular wave) and transmits them to the ABS actuator and electric
unit (control unit).
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfuncti ...
Periodic maintenance
M/T OIL
Inspection
OIL LEAKAGE
Make sure that gear oil is not leaking from transaxle or around it.
OIL LEVEL
Remove filler plug (1) and gasket from transaxle case.
Check the oil level from filler plug mounting hole as shown.
CAUTION:
Do not start engine while checking oil level.
Se ...