Description
The bcm sends a daytime light request to the ipdm e/r via the can communication lines. The power flows through fuse 29 located in fuse block j/b to the daytime light relay coil. When the ipdm e/r operates the daytime light relay, power is sent to the daytime lamps.
Diagnosis procedure
Regarding Wiring Diagram information, refer to EXL-38, "Wiring Diagram".
1.Check daytime light relay voltage supply
Is the inspection result normal? Yes >> go to 3.
No >> go to 2.
2.Check daytime light relay fuse
Check that the following fuses are not blown.
Is the fuse blown? Yes >> replace the blown fuse after repairing the affected circuit.
No >> repair or replace the harness or connector.
3.Check daytime light relay control circuit
Is the inspection result normal? Yes >> go to 4.
No >> repair or replace the harness or connector.
4.Check daytime light relay
Check the daytime light relay. Refer to exl-93, "component inspection".
Is the inspection result normal? YES >> GO TO 5.
NO >> Replace relay.
5.Check daytime light circuit (open or short to ground)
Is the inspection result normal? Yes >> go to 6.
No >> repair or replace the harness or connector.
6.Check daytime light ground circuit for open
Is the inspection result normal? Yes >> inspect daytime light bulb.
No >> repair or replace the harness or connector.
Component inspection
1. Check daytime light relay
Is the inspection result normal? Yes >> inspection end.
No >> replace daytime light relay.
Diagnosis system (BCM) (without intelligent key system)
Common item
COMMON ITEM : CONSULT Function (BCM - COMMON ITEM)
Application item
Consult performs the following functions via can communication with bcm.
Direct diagnostic mode
Description
Ecu identification
The BCM part number is displayed.
Self diagnostic result
...
Steering knuckle
Exploded View
Steering knuckle
Splash guard
Wheel stud
Wheel hub and bearing
Disc brake rotor
Wheel hub lock nut
Nut retainer
Cotter pin
Removal and Installation
REMOVAL
Remove the wheel and tire using power tool. Refer to WT-47, "Exploded
View".
Remove ...
Hvac branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal
Check the terminals and connectors of the a/c auto amp. For damage, bend
and loose connection (unit
side and connector side).
Is the inspection result normal?
...