Nissan Sentra Service Manual: CVT Fluid filter
Exploded View
- Transaxle assembly
- CVT fluid filter
- Fluid filter cover
CVT fluid
Removal and Installation
REMOVAL
- Remove neighboring parts of CVT fluid filter.
- Remove fluid filter cover mounting bolt (A).
- Remove fluid filter cover (1) from transaxle by rotating leftward.
- Remove CVT fluid filter (1) from transaxle.
INSTALLATION
Note the followings and install in the reverse order of removal.
CAUTION:
- Do not reuse fluid filter and fluid filter cover.
- Apply CVT fluid to fluid filter cover.
Inspection
INSPECTION AFTER INSTALLATION
- Start the engine and check visually that there is no leakage of engine coolant and CVT fluid.
- Check CVT fluid level.
CVT Oil warmer
Exploded View
Transaxle assembly
O-ring
CVT oil warmer
CVT fluid
Removal and Installation
REMOVAL
WARNING:
Do not remove the radiator cap when the engine is hot. Serious burns
c ...
Electric oil pump
Exploded View
Transaxle assembly
Electric oil pump sub harness
O-ring
Electric oil pump and motor assembly
CVT fluid
Removal and Installation
REMOVAL
Remove neighboring parts ...
Other materials:
Fuel level sensor unit, fuel filter and fuel pump assembly
Exploded View
Lock ring
Fuel level sensor, fuel filter and fuel
pump assembly
O-ring
Fuel tank
Removal and Installation
WARNING:
Read “General Precautions” when working on the fuel system. Refer to
FL-2, "General Precaution".
NOTE:
When removing componen ...
Front regulator
Exploded View
Front door panel
Front door glass channel front
Front door glass regulator
Front door glass regulator motor
Front door glass channel rear
Front door glass
Front door glass rubber run
Removal and Installation
REMOVAL
WARNING:
Before servicing, turn ignition ...
C1609 Vehicle speed signal
DTC Logic
Dtc detection logic
DTC
Display item
Malfunction detected condition
Possible cause
C1609
CAN VHCL SPEED
Malfunction is detected in vehicle speed signal that
is output from abs actuator and electric unit (control
unit) via can communication. ...
