Nissan Sentra Owners Manual: Cup holders

Nissan Sentra Owners Manual / Instruments and controls / Storage / Cup holders

CAUTION

Avoid abrupt starting and braking when the cup holder is being used to prevent spilling the drink. If the liquid is hot, it can scald you or your passenger.
Use only soft cups in the cup holder.

Hard objects can injure you in an accident.
Do not use bottle holder for any other objects that could be thrown about in the vehicle and possibly injure people during sudden braking or an accident.
Do not use bottle holder for open liquid containers.

Front
Front

Rear
Rear

Soft bottle holder

CAUTION

Do not use bottle holder for any other objects that could be thrown about in the vehicle and possibly injure people during sudden braking or an accident.
Do not use bottle holder for open liquid containers.

Sunglasses holder

To open the sunglasses holder, push and release. Only store one pair of sunglasses in the holder. WARNINGKeep the sunglasses holder closed while driving to prevent an accident. ...

Glove box

Open the glove box by pulling the handle. WARNINGKeep glove box lid closed while driving to help prevent injury in an accident or a sudden stop. ...

Other materials:

A/c auto amp. Connection recognition signal circuit
Description A/c auto amp. Transmits the a/c auto amp. Connection recognition signal to the combination meter Diagnosis procedure (with manual a/c) Regarding wiring diagram information, refer to mwi-28, "wiring diagram". 1.Check a/c auto amp. Connection recognition signal Turn ig ...

DTC/circuit diagnosis
U1000 can comm Description Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description". Dtc logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms a ...

System
Moonroof Moonroof : system diagram Moonroof : system description Moonroof system Input/output signal chart Moonroof operation Moonroof motor assembly operates with the power supply that is output from bcm while ignition switch is on or retained power is operating. Tilt up/ do ...