Nissan Sentra manuals

Nissan Sentra Owners Manual: Control buttons

The control buttons for the Bluetooth® Hands-


The control buttons for the Bluetooth® Hands- Free Phone System are located on the steering wheel.

Press the  button to initiate PHONE/SEND


Press the a VR session or answer an incoming button to initiate
a VR session or answer an incoming call.

You can also use the button to interrupt the system feedback and give a command at once. See “List of voice commands” and “During a call” in this section for more information.

While the voice recognition system PHONE/END


While the voice recognition system is active, press and hold the quit the voice recognition system button for 5 seconds to
quit the voice recognition system at any time.

While using the voice recognition Tuning switch


While using the voice recognition system, tilt the tuning switch up or down to manually control the phone system.

Using the system
The NISSAN Voice Recognition system allows hands-free operation of the Bluetooth® Phone System. If the vehicle is in motion, some commands may not be available so full attention may be given to ...

Connecting procedure
NOTE: The connecting procedure must be performed when the vehicle is stationary. If the vehicle starts moving during the procedure, the procedure will be cancelled. To connect a phone to the ...

Other materials:

Vehicle security system (if so equipped)
The vehicle security system provides visual and audible alarm signals if someone opens the doors when the system is armed. It is not, however, a motion detection type system that activates when a vehicle is moved or when a vibration occurs. The system helps detect vehicle theft but cannot prev ...

Maintenance precautions
When performing any inspection or maintenance work on your vehicle, always take care to prevent serious accidental injury to yourself or damage to the vehicle. The following are general precautions which should be closely observed. WARNING Park the vehicle on a level surface, apply ...

Precaution for Harness Repair
Solder the repair part, and wrap it with tape. [Twisted wire fray must be 110 mm (4.33 in) or less.] Do not bypass the repair point with wire. (If it is bypassed, the turnout point cannot be separated and the twisted wire characteristics are lost.) ...

© 2014-2024 Copyright www.nisentra.com