Nissan Sentra Owners Manual: Car phone or CB radio

Nissan Sentra Owners Manual / Monitor, climate, audio, phone and voice recognition systems / Car phone or CB radio

When installing a CB, ham radio or car phone in your vehicle, be sure to observe the following precautions; otherwise, the new equipment may adversely affect the engine control system and other electronic parts.

WARNING

A cellular phone should not be used for any purpose while driving so full attention may be given to vehicle operation.

Some jurisdictions prohibit the use of cellular phones while driving.
If you must make a call while your vehicle is in motion, the hands free cellular phone operational mode is highly recommended. Exercise extreme caution at all times so full attention may be given to vehicle operation.
If you are unable to devote full attention to vehicle operation while talking on the phone, pull off the road to a safe location and stop your vehicle.

CAUTION

Keep the antenna as far away as possible from the electronic control modules.
Keep the antenna wire more than 8 in (20 cm) away from the electronic control system harnesses. Do not route the antenna wire next to any harness.
Adjust the antenna standing-wave ratio as recommended by the manufacturer.
Connect the ground wire from the CB radio chassis to the body.
For details, consult a NISSAN dealer.

Application Download

Once connected, the NissanConnect™ App will search your phone to determine which compatible applications are currently installed. The user will then choose which apps they want to bring into the ...

Bluetooth® Hands-Free Phone System without Navigation System (Type A) (if so equipped)

WARNING Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be ...

Other materials:

Instrument panel
Headlight/fog light (if so equipped)/turn signal switch Steering wheel switch for trip computer, audio control and Bluetooth® Hands-Free Phone System (if so equipped) Driver’s supplemental air bag/Horn Meters and gauges Cruise control main/set switches (if so equipped) ...

Low tire pressure warning lamp blinks
Diagnosis Procedure NOTE: If low tire pressure warning lamp repeats blinking ON for 2 seconds and OFF for 0.2 seconds, wake-up operation for all transmitters is not complete. Carry out transmitter wake-up operation. Refer to WT-22, "Work Procedure". 1.CHECK BCM CONNECTOR Turn ...

P1226 TP Sensor
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P1226 CTP LEARNING-B1 (CTP LEARNING-B1) Closed throttle position learning is not performed successfully, repeatedly. Electric thr ...