Nissan Sentra Service Manual: Can system (type 3)
Dtc/circuit diagnosis
- Main line between ipdm-e and dlc circuit
- Main line between dlc and av circuit
- Ecm branch line circuit
- Abs branch line circuit
- Ipdm-e branch line circuit
- Tcm branch line circuit
- A-bag branch line circuit
- Dlc branch line circuit
- Eps branch line circuit
- M&a branch line circuit
- Strg branch line circuit
- AV branch line circuit
- Bcm branch line circuit
- Can communication circuit
Can communication circuit
Diagnosis procedure
1.Connector inspection
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Disconnect all the unit connectors on can communication syste ...
Main line between ipdm-e and dlc circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and ...
Other materials:
Manual control
While using the voice recognition system, it is
possible to select menu options by using the
steering wheel controls instead of speaking voice
commands. This can be especially helpful if the
noise of driving makes it difficult for the voice
recognition system to accurately interpret commands.
...
Drive belt
Exploded View
Alternator
Drive belt auto-tensioner
Crankshaft pulley
A/C compressor
Water pump
Drive belt
Possible use range
New drive belt range
Indicator
Removal and Installation
REMOVAL
Remove the front fender protector (RH) front side bolts and clips. Refer ...
Engine block heater (if so equipped)
Engine block heaters are used to assist with cold
temperature starting.
The engine block heater should be used when
the outside temperature is 20°F (-7°C) or lower.
WARNING
Do not use your engine block heater
with an ungrounded electrical system or
a 2-pronged adapter. You ...
