Nissan Sentra manuals

Nissan Sentra Service Manual: Can communication circuit

Nissan Sentra Service Manual / Electrical & power control / Lan system / Can system (type 5) / Can communication circuit

Diagnosis procedure

1.Connector inspection

  1. Turn the ignition switch off.
  2. Disconnect the battery cable from the negative terminal.
  3. Disconnect all the unit connectors on CAN communication system.
  4. Check terminals and connectors for damage, bend and loose connection.

Is the inspection result normal? Yes >> go to 2.

No >> repair the terminal and connector.

2.Check harness continuity (short circuit)

Check the continuity between the data link connector terminals.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 3.

NO >> Check the harness and repair the root cause.

3.Check harness continuity (short circuit)

Check the continuity between the data link connector and the ground.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 4.

NO >> Check the harness and repair the root cause.

4.Check ecm and bcm termination circuit

  1. Remove the ecm and the bcm.
  2. Check the resistance between the ecm terminals.


  1. Check the resistance between the bcm terminals.

Is the measurement value within the specification?


Is the measurement value within the specification? Yes >> go to 5.

No >> replace the ecm and/or the bcm.

5.Check symptom

Connect all the connectors. Check if the symptoms described in the “symptom (results from interview with customer)” are reproduced.

Inspection result

Reproduced>>go to 6.

Non-reproduced>>start the diagnosis again. Follow the trouble diagnosis procedure when past error is detected.

6.Check unit reproduction

Perform the reproduction test as per the following procedure for each unit.

  1. Turn the ignition switch off
  2. Disconnect the battery cable from the negative terminal.
  3. Disconnect one of the unit connectors of can communication system.

Note:

Ecm and bcm have a termination circuit. Check other units first.

  1. Connect the battery cable to the negative terminal. Check if the symptoms described in the “symptom (results from interview with customer)” are reproduced.

Note:

Although unit-related error symptoms occur, do not confuse them with other symptoms.

Inspection result

Reproduced>>connect the connector. Check other units as per the above procedure.

Non-reproduced>>replace the unit whose connector was disconnected.

BCM  branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the bcm for damage, bend and ...

Power control system
...

Other materials:

Summary of functions
The multi-information display presents the driver with a variety of driving- related data, such as the current outside temperature. The multi-information display can also be used to change the display settings and other settings. Indicators Driving assist system status display area Disp ...

Unbalance steering wheel turning force and return between right and left
Description Unbalance steering wheel turning force and return between right and left. Diagnosis Procedure 1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP Check the EPS warning lamp while engine is running. Does the EPS warning lamp turn OFF? YES >> GO TO 2. NO >> Refer to S ...

Service data and specifications (SDS)
Steering Wheel Steering Angle Steering Column STEERING COLUMN LENGTH TILT MECHANISM OPERATING RANGE Power Steering Gear STEERING OUTER SOCKET AND INNER SOCKET RACK STROKE ...

© 2014-2024 Copyright www.nisentra.com