DTC Logic
Dtc detection logic
DTC | Display item | Malfunction detected condition | Possible cause |
C1609 | CAN VHCL SPEED |
|
|
Dtc confirmation procedure
1.PRECONDITIONING
If dtc confirmation procedure has been previously conducted, always turn ignition switch off and wait at least 10 seconds before conducting the next test.
>> Go to 2.
2.Dtc reproduction procedure
With consult
Turn the ignition switch OFF to ON.
Perform EPS self-diagnosis.
Is DTC c1609 detected? Yes >> proceed to diagnosis procedure. Refer to stc-29, "diagnosis procedure".
No >> inspection end.
Diagnosis Procedure
1.Perform abs actuator and electric unit (control unit) self-diagnosis
With consult
Turn the ignition switch off to on.
Perform ABS self-diagnosis.
Is any dtc detected? Yes >> check the dtc. Refer to stc-14, "dtc index".
No >> go to 2.
2.CHECK TERMINALS AND HARNESS CONNECTORS
Check eps control unit pin terminals for damage or loose connection with harness connector.
Is the inspection result normal? Yes >> go to 3.
No >> repair or replace the malfunctioning parts.
3.Perform self-diagnosis
With consult
Perform EPS self-diagnosis.
Is dtc c1609 detected? Yes >> replace eps control unit. Refer to stc-39, "removal and installation".
No >> check intermittent incident. Refer to gi-39, "intermittent incident".
Cooling fan
Component Function Check
1.CHECK COOLING FAN FUNCTION
With CONSULT
Turn ignition switch ON.
Perform “FAN” in “ACTIVE TEST” mode of “ENGINE” using CONSULT
Check that cooling fan operates at low speed or high speed.
Without CONSULT
Activate IPDM E/R auto ...
Malfunction indicator lamp
Component Function Check
1.CHECK MIL FUNCTION
Turn ignition switch ON.
Check that MIL lights up.
Is the inspection result normal?
YES >> INSPECTION END
NO >> Proceed to EC-467, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK DTC WITH ECM
Check that DTC UXXXX i ...
Precaution for Work
When removing or disassembling each component, be careful not to damage
or deform it. If a component
may be subject to interference, be sure to protect it with a shop cloth.
When removing (disengaging) components with a screwdriver or similar
tool, be sure to wrap the component
with a ...