Nissan Sentra Service Manual: C1607, C1608 EPS Control unit
DTC Logic
DTC DETECTION LOGIC
| Dtc | Display item | Malfunction detected condition | Possible cause |
| C1607 | EEPROM | When the memory (EEPROM) system malfunction is detected in EPS control unit. | Eps control unit |
| C1608 | CONTROL UNIT | When the internal malfunction is detected in EPS control unit. |
Dtc confirmation procedure
1.Preconditioning
If dtc confirmation procedure has been previously conducted, always turn ignition switch off and wait at least 10 seconds before conducting the next test.
>> Go to 2.
2.DTC REPRODUCTION PROCEDURE
With consult
-
Turn the ignition switch OFF to ON.
-
Perform eps self-diagnosis.
Is dtc c1607 or c1608 detected? Yes >> proceed to diagnosis procedure. Refer to stc-28, "diagnosis procedure".
No >> inspection end.
Diagnosis Procedure
1.CHECK TERMINALS AND HARNESS CONNECTORS
Check eps control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace the malfunctioning parts.
Is the inspection result normal? Yes >> go to 2.
No >> repair or replace the malfunctioning parts.
2.Perform self-diagnosis
With consult
-
Erase self-diagnostic results for EPS.
-
Turn the ignition switch OFF, and then wait 10 seconds and more.
-
Perform self-diagnosis for EPS.
Is DTC C1607 or C1608 detected? YES >> Replace EPS control unit. Refer to STC-39, "Removal and Installation".
NO >> Check intermittent incident. Refer to GI-39, "Intermittent Incident".
C1606 EPS Motor
DTC Logic
DTC DETECTION LOGIC
Dtc
Display item
Malfunction detected condition
Possible cause
C1606
EPS MOTOR
When the motor driver malfunction of EPS control
unit o ...
C1609 Vehicle speed signal
DTC Logic
Dtc detection logic
DTC
Display item
Malfunction detected condition
Possible cause
C1609
CAN VHCL SPEED
Malfunction is detected in vehicle speed sig ...
Other materials:
Automatic door locks
All doors lock automatically when the vehicle
speed reaches 15 MPH (24 km/h).
All doors unlock automatically when the ignition
is placed in the OFF position (models
with Intelligent Key system) or when the key
is removed from the ignition switch (models
without Intelligent Key system) ...
Rear door
Door assembly
Door assembly : removal and installation
Caution:
Use two people when removing or installing the rear door assembly
due to its heavy weight.
When removing and installing rear door assembly, support rear door
with a suitable tool.
Removal
Remove rear door assembly h ...
Audio operation precautions
Compact disc (CD) player
CAUTION
Do not force a compact disc into the CD
insert slot. This could damage the CD
and/or CD player.
Trying to load a CD with the CD door
closed could damage the CD and/or CD
player.
Only one CD can be loaded into the CD
player at a time.
Only ...
