DTC Logic
DTC DETECTION LOGIC
DTC | Display Item | Malfunction detected condition | Possible causes |
C1130 | ENGINE SIGNAL 1 | When a malfunction is detected in ECM system. |
|
DTC CONFIRMATION PROCEDURE
1.CHECK SELF DIAGNOSTIC RESULT
With CONSULT.
Turn ignition switch ON.
Perform self diagnostic result.
Is DTC C1130 detected? YES >> Proceed to diagnosis procedure. Refer to BRC-76, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.CHECK SELF DIAGNOSTIC RESULT FOR ENGINE SYSTEM
With CONSULT.
Perform self diagnostic result. Refer to EC-66, "CONSULT Function".
Are any ECM DTCs detected? YES >> Refer to EC-94, "DTC Index".
NO >> GO TO 2.
2.CHECK SELF DIAGNOSTIC RESULT FOR ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
With CONSULT
Perform self diagnostic result and erase DTCs.
Turn ignition switch OFF.
Start engine and drive vehicle for a short period of time.
Check that malfunction indicator lamp (MIL) turns OFF.
Stop vehicle and perform self diagnostic result.
Is DTC C1130 detected? YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC-110, "Removal and Installation".
NO >> Check pin terminals and connection of connectors for abnormal conditions. Repair or replace malfunctioning components.
Special Service Tool
The actual shapes of Kent-Moore tools may differ from those of special
service tools illustrated here.
CAUTION:
Every time the vehicle is lifted up, maintain the complete vehicle
curb condition.
Since the vehicle's center of gravity changes when removing main
parts on the front si ...
NISSAN Intelligent Key® (if so equipped)
Replace the battery in the Intelligent Key as follows:
Remove the mechanical key from the Intelligent
Key.
Insert a small screwdriver A into the slit B
of the corner and twist it to separate the
upper part from the lower part. Use a cloth to
protect the casing.
Replace the battery wi ...
Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
NOTE:
“DTC” includes DTC at the 1st trip.
1.OBTAIN INFORMATION ABOUT SYMPTOM
Refer to TM-140, "Diagnostic Work Sheet" and interview the customer to obtain
the malfunction information
(conditions and environment when the malfunctio ...