Nissan Sentra manuals

Nissan Sentra Service Manual: Body repair

Rear air spoiler
Removal and installation Rear air spoiler High mounted stop lamp connector (if equipped) Trunk lid Grommet Nut Front Removal Remove trunk lid finisher. Refer to INT-45, ...

Vehicle information
Body exterior paint color M = Metallic, S = Solid, 2S = Solid and Clear, 2P = 2-Coat Pearl, 3P = 3-Coat Pearl, PM = Pearl Metallic, t = Primerless Diamond Clear coat, Black is solvent base ...

Other materials:

S connector circuit
Description The starter motor magnetic switch is supplied with power when the ignition switch is turned to the START position while the selector lever is in the P (Park) or N (Neutral) position (CVT Models) or the clutch pedal is depressed (M/T Models). Diagnosis Procedure Regarding Wiring ...

Precaution for Work
When removing or disassembling each component, be careful not to damage or deform it. If a component may be subject to interference, be sure to protect it with a shop cloth. When removing (disengaging) components with a screwdriver or similar tool, be sure to wrap the component with a ...

Installing front license plate
Use the following steps to mount the front license plate: Make holes on the plastic finisher at the location mark (small dimple) using a 0.20 in (5 mm) drill. Apply light pressure to the drill. Install the license plate holder using the two screws provided with the holder. Mount ...

В© 2014-2026 Copyright www.nisentra.com