Nissan Sentra Owners Manual: Before starting the engine

Nissan Sentra Owners Manual / Starting and driving / Before starting the engine

Make sure the area around the vehicle is clear.
Check fluid levels such as engine oil, coolant, brake and clutch fluid(if so equipped), and windshield-washer fluid as frequently as possible, or at least whenever you refuel.
Check that all windows and lights are clean.
Visually inspect tires for their appearance and condition. Also check tires for proper inflation.
Lock all doors.
Position seat and adjust head restraints/headrests.
Adjust inside and outside mirrors.
Fasten seat belts and ask all passengers to do likewise.
Check the operation of warning lights when the ignition switch is placed in the ON position.
See “Warning/indicator lights and audible reminders” in the “Instruments and controls” section of this manual.

NISSAN vehicle immobilizer system

The NISSAN Vehicle Immobilizer system will not allow the engine to start without the use of the registered key. If the engine fails to start using a registered key (for example, when interferenc ...

Starting the engine

Apply the parking brake. CVT model: Move the shift lever to P (Park) or N (Neutral). P (Park) is recommended. The shift lever cannot be moved out of P (Park) and into any of the other gea ...

Other materials:

Rear seat belt
Exploded View - Seat Belt Retractor Seat belt retractor (RH) Seat belt retractor (center) Seat belt retractor (LH) Front Removal and Installation - Seat Belt Retractor REMOVAL Remove the rear parcel shelf finisher. Refer to INT-33, "Removal and Installation". Re ...

Tire pressure warning system
Your vehicle is equipped with a tire pressure warning system that uses tire pressure warning valve and transmitters to detect low tire inflation pressure before serious problems arise. Vehicles without a tire inflation pressure display function If the tire pressure drops below a predetermined le ...

C1116 Stop lamp switch
DTC Logic DTC DETECTION LOGIC DTC Display item Malfunction detected condition Possible cause C1116 STOP LAMP SW When stop lamp switch circuit is open. Harness or connector Stop lamp switch ABS actuator and electric unit (control unit) ...