Nissan Sentra Service Manual: Battery current sensor
Exploded view
- Battery current sensor
- Current sensor harness connector
Removal and installation
Removal
- Loosen the battery terminal nut and disconnect battery negative terminal. Refer to PG-50, "Exploded View".
- Disconnect the harness connector from current sensor.
- Remove the battery current sensor from the negative terminal.
Installation
Installation is in the reverse order of removal.
Reset electronic systems as necessary. Refer to pg-7, "additional service when removing battery negative terminal : special repair requirement".
Battery terminal with fusible link
Exploded view
Battery terminal with fusible link
Harness connector
Removal and installation
Removal
Loosen the battery terminal nuts and disconnect both battery negative and
positive ...
Service data and specifications (SDS)
Battery
...
Other materials:
Ecu diagnosis information
Abs actuator and electric unit
(control unit)
Reference Value
VALUES ON THE DIAGNOSIS TOOL
CAUTION:
The display shows the control unit calculation data, so a
normal value might be displayed even in the
event the output circuit (harness) is open or short-circuited.
...
Door mirror
Exploded view
Door mirror cover
(with side turn signal lamp)
Door mirror housing
Door mirror actuator
Glass mirror
Door mirror cover
(without side turn signal lamp)
: Pawl
Door mirror assembly
Door mirror assembly : removal and installation
Removal
Caution:
Be careful no ...
Washer nozzle & tube
Exploded view
Check valve
Washer tube
Washer tank
Washer pump
Washer nozzle
Clip
Washer nozzle
Washer nozzle : removal and installation
REMOVAL
Disconnect the washer nozzle from the hood by pushing on the
nozzle in the order and direction shown.
Disconnect the ...
