Nissan Sentra Service Manual: Basic inspection
Diagnosis and repair work flow
Work flow
Detailed flow
1.Obtain information about symptom
Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurs.
>> GO TO 2.
2.Check symptom
- Check the symptom based on the information obtained from the customer.
- Check if any other malfunctions are present.
>> Go to 3.
3.Dtc/system diganosis
Perform a dtc/system diagnosis and repair or replace any malfunctioning part.
>> Go to 4.
4.Final check
Check that the sport mode functions normally.
Does it operation normally? Yes >> end of trouble diagnosis no >> go to 2.
Wiring diagram
Sport mode system
Wiring diagram
...
Dtc/circuit diagnosis
Sport mode switch
Component function check
1. Check sport mode switch operation
Turn ignition switch on.
Check sport mode indicator lamp turns on/off on combination meter when
turn sport m ...
Other materials:
Description
NOTICE:
Trouble diagnoses indicate work procedures required to diagnose problems
effectively. Observe the following
instructions before diagnosing.
Before performing trouble diagnoses, read the “Work Flow” in each
section.
After repairs, re-check that the problem has been comp ...
P0112, P0113 IAT Sensor
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0112
IAT SEN/CIRCUIT- B1
(Intake air temperature
sensor 1 circuit low bank 1)
An excessively low voltage from the intake air
tem ...
Side window glass
Components
Side window glass
Spacer
Headlining
Rear body pillar
Rear pillar finisher
Rear door weatherstrip
Primer area
Adhesive
7 mm (0.3 in)
12 mm (0.5 in)
Removal and Installation
REMOVAL
Remove the rear pillar finisher. Refer to INT-29, "REAR PILLAR FIN ...
