Description
“B” terminal circuit supplies power to charge the battery and to operate the vehicles electrical system.
Diagnosis procedure
Regarding wiring diagram information. Refer to chg-9, "wiring diagram".
1.Check “b” terminal connection
Is the inspection result normal? Yes >> go to 2.
No >> repair terminal “b” connection. Confirm repair by performing complete charging system test using the exp-800 ni or gr8-1200 ni (if available). Refer to applicable instruction manual for proper testing procedures.
2.Check “b” terminal circuit
Check voltage between generator “b” terminal and ground.
Is the inspection result normal? Yes >> go to 3.
No >> check harness for open between generator and fusible link.
3.Check “b” terminal connection (voltage drop test)
Is the inspection result normal? YES >> “B” terminal circuit is normal. Refer to CHG-14, "Work Flow (With EXP-800 NI or GR8-1200 NI)" or CHG-17, "Work Flow (Without EXP-800 NI or GR8-1200 NI)".
NO >> Check harness between battery and generator for continuity.
Dtc/circuit diagnosis
U1000 can comm circuit
Description
Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description".
Dtc logic
DTC DETECTION LOGIC
CONSULT Display
DTC Detection Condition
Possible Cause
CAN COMM CIRCUIT
[U1000]
When IPDM E/R cannot communicate with CAN com ...
Dtc/circuit diagnosis
Door mirror remote control switch (mirror switch/changeover switch)
Component Inspection
1.Check mirror switch & changeover switch
Turn ignition switch off.
Disconnect door mirror remote control switch connector.
Check door mirror remote control switch.
Is the inspection result ...
Maintenance requirements
Your NISSAN has been designed to have minimum
maintenance requirements with long service
intervals to save you both time and money;
however, some day-to-day and regular maintenance
is essential to maintain your NISSAN’s
good mechanical condition as well as its emissions
and engine performanc ...