Nissan Sentra manuals

Nissan Sentra Service Manual: Av branch line circuit

Diagnosis Procedure

1.Check connector

  1. Turn the ignition switch off.
  2. Disconnect the battery cable from the negative terminal.
  3. Check the terminals and connectors of the av control unit for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? Yes >> go to 2.

No >> repair the terminal and connector.

2.Check harness for open circuit

  1. Disconnect the connector of av control unit.
  2. Check the resistance between the av control unit harness connector terminals.


Is the measurement value within the specification?


Is the measurement value within the specification? Yes >> go to 3.

No >> repair the av control unit branch line.

3.Check power supply and ground circuit

Check the power supply and the ground circuit of the av control unit. Refer to the following.

Is the inspection result normal? Yes (present error)>>replace the av control unit. Refer to the following.

Yes (past error)>>error was detected in the av control unit branch line.

No >> repair the power supply and the ground circuit.

Strg branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the steering angle sensor fo ...

Hvac branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the a/c auto amp. For damage ...

Other materials:

Instrument panel assembly
Exploded View Instrument panel assembly Ambient sensor Defroster grille (RH) Defroster grille (LH) Sunload sensor (if equipped) Side defroster grille (LH) Instrument side finisher (LH) Side ventilator grille (LH) Steering column upper cover Combination switch Steering col ...

Precaution
Precaution for supplemental restraint system (srs) "air bag" and "seat belt pre-tensioner" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury ...

Settings display
â—† Changing settings Use the meter control switches on the steering wheel to change settings. 1. Press or to select . 2. Operate the switches to select a desired item. 3. Press or press and hold . The available settings will differ depending on if is pressed or pressed and held. Follo ...

© 2014-2024 Copyright www.nisentra.com