Nissan Sentra manuals

Nissan Sentra Service Manual: Auto operation does not operate

Diagnosis Procedure

1. Perform initialization procedure

Perform initialization procedure.

Refer to rf-18, "additional service when replacing control unit : special repair requirement".

Is the inspection result normal? Yes >> inspection end.

No >> perform basic inspection. Refer to rf-16, "work flow".

Moonroof does not operate properly
Diagnosis Procedure 1. Check bcm power supply and ground circuit Check BCM power supply and ground circuit. Refer to PWC-31, "BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) : Diag ...

Moonroof does not operate antipinch function
Diagnosis Procedure 1. Perform initialization procedure Perform initialization procedure. Refer to rf-18, "additional service when replacing control unit : special repair requirement" ...

Other materials:

P0116 ECT Sensor
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0116 ECT SEN/CIRC (Engine coolant temperature sensor 1 circuit range/performance) The comparison result of signals transmitted t ...

P099B Shift solenoid G
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P099B SHIFT SOLENOID G (Shift Solenoid G Control Circuit Low) The TCM high clutch & reverse brake solenoid valve current monitor ...

Brake pedal
Inspection BRAKE PEDAL HEIGHT Check the brake pedal height (H1) between the dash lower panel (1) and the brake pedal upper surface. Brake pedal height (H1) : Refer to BR-54, "Brake Pedal". CAUTION: Check the brake pedal height with the floor trim removed. STOP LAMP SWITCH AND BR ...

В© 2014-2026 Copyright www.nisentra.com