Nissan Sentra Owners Manual: Audio system voice commands
To access the audio system voice commands:
- Press the button.
- Say “Audio”
- Speak a command from the following available commands:
- Play (AM, FM, etc.) Allows user to select radio band
- Tune AM (number) Allows user to tune directly to a desired AM frequency
- Tune FM (number) Allows user to tune directly to a desired FM frequency
- SXM channel (number) Allows user to tune directly to a desired SXM station (if so equipped)
- CD Track (number) Allows user to select track to be played
- Play Song (name) Allows user to select song name to be played
- Play Artist (name) Allows user to select artist to be played
- Play Album (name) Allows user to select album name to be played
For more information about the audio system, see “Audio system” in this section.
Navigation System voice commands
The following voice commands are available for
the Navigation System:
Street Address (address)
Points of Interest (name)
POI by Category
Home
Address Book
Previous Destinations
Enter ...
Information voice commands
The following voice commands are available for
the information functions of the Navigation System:
Traffic
Fuel Prices
Stocks
Movie Listings
Current Weather
Weather Map
5 — day Fore ...
Other materials:
Wheel alignment
Inspection
PRELIMINARY INSPECTION
WARNING:
Always adjust the wheel alignment with the vehicle on a flat surface.
NOTE:
If the wheel alignment is out of specification, inspect and replace any
damaged or worn rear suspension parts
before making any adjustments.
Check and adjust the wheel ...
Performance test
Inspection
INSPECTION PROCEDURE
Connect recovery/recycling/recharging equipment (for HFC-134a) or
manifold gauge.
Start the engine, and set to the following condition.
Test condition
Maintain test condition until A/C system becomes stable. (Approximately
10 minutes)
Check t ...
Control buttons
The control buttons for the Bluetooth® Hands-Free
Phone System are located on the steering wheel.
PHONE/SEND
Press the button to
initiate a
VR session or answer an incoming
call.
You can also use the button to
interrupt the system feedback and
give a command at once. See “L ...
