Nissan Sentra Service Manual: ASCD Indicator

Nissan Sentra Service Manual / Engine / Engine control system / Dtc/circuit diagnosis / ASCD Indicator

Component Function Check

1.CHECK ASCD INDICATOR FUNCTION

Check ASCD indicator under the following conditions.

ASCD INDICATOR	CONDITION		SPECIFICATION
CRUISE LAMP	Ignition switch: ON	MAIN switch: Pressed at the 1st time → at the 2nd time	ON → OFF
SET LAMP	MAIN switch: ON When vehicle speed is between 38 km/h (24 MPH) and 160 km/h (100 MPH)	ASCD: Operating	ON
SET LAMP		ASCD: Not operating	OFF

Is the inspection result normal? YES >> INSPECTION END

NO >> Proceed to EC-449, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC

Check that DTC UXXXX is not displayed.

Is the inspection result normal? YES >> GO TO 2.

NO >> Perform trouble diagnosis for DTC UXXXX.

2.CHECK DTC WITH COMBINATION METER

Check DTC with combination meter. Refer to MWI-26, "DTC Index".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace error-detected parts.

3.CHECK INTERMITTENT INCIDENT

Check intermittent incident. Refer to GI-39, "Intermittent Incident".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".

NO >> Repair or replace error-detected parts.

Brake pedal position switch

Component Function Check 1.CHECK BRAKE PEDAL POSITION SWITCH FUNCTION With CONSULT Turn ignition switch ON. Select вЂњENGINEвЂќ using CONSULT. Select вЂњBRAKE SW1вЂќ in вЂњDA ...

Fuel injector

Component Function Check 1.INSPECTION START Turn ignition switch to START. Is any cylinder ignited? YES >> GO TO 2. NO >> Proceed to EC-450, "Diagnosis Procedure". 2.CH ...

Other materials:

Removal and installation
Ipdm e/r Exploded view Ipdm e/r IPDM E/R cover A Ipdm e/r cover b Removal and installation Caution: Ipdm e/r integrated relays are not serviceable and must not be removed from unit. Removal Remove inlet air duct (upper). Refer to em-25, "removal and installation" ...

Troubleshooting guide
Symptom Possible Cause When pushing the ignition switch to stop the engine The P (Park) warning light in the instrument panel illuminates and the inside chime sounds continuously. The shift lever is not in the P (Park) position. Make sure that the shift ...

Ambient sensor signal circuit
Description It detects outside air temperature and converts it into a resistance value which is then input into the combination meter. Diagnosis Procedure Regarding wiring diagram information, refer to mwi-28, "wiring diagram". 1.Check ambient sensor signal circuit Turn igniti ...