Nissan Sentra Owners Manual: Air cleaner

Nissan Sentra Owners Manual / Maintenance and do-it-yourself / Air cleaner

The air cleaner filter should not be cleaned and

The air cleaner filter should not be cleaned and reused. Replace it according to the maintenance log shown in the “NISSAN Service and Maintenance Guide.” To remove the air cleaner filter:

Unlatch the retaining clips A .
Pull up at points B and remove.
Pull up and remove air cleaner housing C .
Remove the air cleaner filter, Wipe the inside of the air cleaner filter housing and the cover with a damp cloth, then replace air cleaner filter.

NOTE:

After installing a new air cleaner, make sure the air cleaner cover is seated in the housing and latch the clips.

WARNING

Operating the engine with the air cleaner removed can cause you or others to be burned. The air cleaner not only cleans the air, it stops the flame if the engine backfires. If it isn’t there, and the engine backfires, you could be burned. Do not drive with the air cleaner removed, and be careful when working on the engine with the air cleaner removed.
Never pour fuel into the throttle body or attempt to start the engine with the air cleaner removed. Doing so could result in serious injury.

In-cabin microfilter

The in-cabin microfilter restricts the entry of airborne dust and pollen particles and reduces some objectionable outside odors. The filter is located behind the trim panel near the accelerator pedal. Refer to the “NISSAN Service and Maintenance Guide” for change intervals.

If replacement is required, see your NISSAN dealer.

Spark plugs

Replacing spark plugs WARNINGBe sure the engine and ignition switch are off and that the parking brake is engaged securely. CAUTION Be sure to use the correct socket to remove ...

Windshield wiper blades

...

Other materials:

P0172 Fuel injection system function
DTC Logic DTC DETECTION LOGIC With the Air/Fuel Mixture Ratio Self-Learning Control, the actual mixture ratio can be brought closely to the theoretical mixture ratio based on the mixture ratio feedback signal from the A/F sensors 1. The ECM calculates the necessary compensation to correct th ...

Multiport fuel injection system
MULTIPORT FUEL INJECTION SYSTEM : System Description SYSTEM DIAGRAM *1: ECM determines the start signal status by the signals of engine speed and battery voltage. *2: M/T models *3: CVT models *4: This sensor is not used to control the engine system under normal conditions. SYSTEM DES ...

Door sash tape
Exploded view Front door sash upper tape Front door assembly Rear door assembly Front door sash rear tape Rear door sash front tape Rear door sash rear tape Rear door sash upper tape Front door sash tape FRONT DOOR SASH TAPE : Removal and Installation REMOVAL Heat door sash ...