Nissan Sentra Service Manual: 1144 Incomplete steering angle sensor adjustment
DTC Logic
Dtc detection logic
| Dtc | Display item | Malfunction detected condition | Possible causes |
| C1144 | St ang sen signal | When neutral position adjustment of steering angle sensor is not complete. |
|
Dtc confirmation procedure
1.Check self diagnostic result
With consult
-
Turn ignition switch on.
-
Perform self diagnostic result.
Is dtc C1144 detected? Yes >> proceed to diagnosis procedure. Refer to brc-82, "diagnosis procedure".
No >> inspection end.
Diagnosis Procedure
1.Adjust the neutral position of steering angle sensor
Perform neutral position adjustment of steering angle sensor. Refer to brc-54, "work procedure".
>> Go to 2.
2.Check self diagnostic result
With consult.
Perform self diagnostic result.
Is dtc c1144 detected? Yes >> go to 3.
No >> inspection end.
3.Check steering angle sensor system
Check steering angle sensor system. Refer to brc-80, "diagnosis procedure".
Is the inspection result normal? Yes >> replace abs actuator and electric unit (control unit). Refer to brc-110, "removal and installation".
No >> repair or replace malfunctioning components.
C1143 Steering angle sensor
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1143
ST ANG SEN CIRCUIT
When a malfunction is detected in steering angl ...
C1155 BR Fluid level low
DTC Logic
Dtc detection logic
Dtc
Display item
Malfunction detected condition
Possible cause
C1155
C1155 br fluid level low
Brake fluid level is low or communication l ...
Other materials:
Transaxle side
TRANSAXLE SIDE : Removal and Installation
Remove boot after drive shaft is removed from the vehicle.
For drive shaft removal and installation, follow the instructions bellow.
6M/T: Refer to FAX-18, "6M/T : Removal and Installation (LH)".
Except 6M/T: Refer to FAX-26, "EXCEPT ...
Windows
Power windows
WARNING
Make sure that all passengers have
their hands, etc. inside the vehicle while
it is in motion and before closing the
windows. Use the window lock switch to
prevent unexpected use of the power
windows.
Do not leave children unattended inside
...
Push-Button Ignition Switch (if so equipped)
WARNINGDo not operate the push-button ignition
switch while driving the vehicle except in
an emergency. (The engine will stop when
the ignition switch is pushed 3 consecutive
times in quick succession or the ignition
switch is pushed and held for more
than 2 seconds.) If ...
