Warning:
After cleaning clutch disc, wipe it with a dust collector. Do not use compressed air.
CAUTION:
Clutch fluid use refer to Fluids and Lubricants.
Do not reuse drained clutch fluid.
Keep painted surface on the body or other parts free of clutch fluid. If it spills, wipe up immediately and wash the affected area with water.
Do not use mineral oils such as gasoline or kerosene. It will ruin the rubber parts of the hydraulic system.
Do not reuse CSC (Concentric Slave Cylinder). Because CSC slides back to the original position every time when removing transaxle assembly. At this timing, dust on the sliding parts may damage a seal of CSC and may cause clutch fluid leakage. Refer to Removal and Installation.
Do not disassemble clutch master cylinder and CSC.
Precaution for Procedure Without Cowl Top CoverDiagnosis Procedure
Diagnosis Procedure
CHECK DOOR MIRROR DEFOGGER FUSE
Check if the following fuse in fuse block (J/B)
is blown:
...
Push starting
CAUTION
Do not push start this vehicle. The
three-way catalyst may be damaged.
Continuously Variable Transmission
(CVT) models and Manual Transmission
(MT) cannot be push-started or towstarted.
Attempting to do so may cause
transmission damage
For manual transmission (MT) models,
...
P0452 EVAP Control system pressure sensor
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0452
EVAP SYS PRES SEN
(Evaporative emission system
pressure sensor/switch low)
An excessively low voltage from the
sensor is se ...