Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
A/c Switch Assembly
Removal and Installation
Removal and Installation
REMOVAL
Remove instrument finisher B. Refer to Removal and Installation.
Remove the A/C switch assembly screws
(A). 
|
|
: Pawl |
Using a suitable tool, release pawls and remove A/C switch assembly.
INSTALLATION
Installation is in the reverse order of removal.
A/c Amp.
Removal and Installation
Removal and Installation
REMOVAL
Remove center console. Refer to Removal and Installation.
Disconnect harness connectors from A/C amp.
Remove
screws (A), then remove A/C amp. 
INSTALLATION
Installation is in the reverse order of removal.
Intake Sensor
Removal and Installation
Removal and Installation
REMOVAL
Remove evaporator. Refer to Removal and Installation.
Separate intake sensor from evaporator.
INSTALLATION
Installation is in the reverse order of removal.
Refrigerant Pressure Sensor
Removal and Installation
Removal and Installation
The refrigerant pressure sensor is an integral part of the high pressure pipe.
If replacement of the refrigerant pressure sensor is necessary, replace the high pressure pipe. Refer to Removal and Installation.
Door Motor
Exploded View
Exploded View
|
1. |
Heating and cooling unit assembly |
2. |
Mode door motor |
3. |
Air mix door motor |
|
4. |
Blower motor unit |
5. |
Intake door motor |
Intake Door Motor
Removal and Installation
Removal and Installation
REMOVAL
Remove heating and cooling unit assembly. Refer to Removal and Installation.
Disconnect harness connector from intake door motor.
Remove intake door motor screws and the intake door motor.
INSTALLATION
Installation is in the reverse order of removal.
Mode Door Motor
Removal and Installation
Removal and Installation
REMOVAL
Remove knee air bag module RH. Refer to Removal and Installation.
Disconnect the harness connector from the mode door motor.
Remove the mode door motor screws and the mode door motor.
INSTALLATION
Installation is in the reverse order of removal.
Air Mix Door Motor
Removal and Installation
Removal and Installation
REMOVAL
Remove knee air bag module RH. Refer to Removal and Installation.
Disconnect the harness connector from the air mix door motor.
Remove the air mix door motor screws and the air mix door motor.
INSTALLATION
Installation is in the reverse order of removal.
Other materials:
Sun visors
1. To reduce glare from the front, pull down the main sun visor 1.
2. To block glare from the side window, remove the main sun visor from the center
mount and swing it toward the side 2.
3. To extend coverage, slide the sun visor extension in or out as needed 3.
CAUTION
Always return th ...
Steering System. Service Data and Specifications (sds). Service Data and Specifications (sds)
Service Data and Specifications (sds)
Steering Wheel
Steering Wheel
Steering wheel axial end
play
0 mm (0 in)
Steering wheel play
...
Vacuum Lines
Exploded View
Exploded View
1.
Vacuum hose
2.
Hose clamp
3.
Brake boos ...