Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
REMOVAL
Remove the front wheel and tire using power tool. Refer to Removal and Installation.
Remove the front under cover. Refer to Removal and Installation.
Remove front bumper. Refer to Removal and installation.
Separate the steering gear from the lower shaft. Refer to Exploded View.
Separate the steering outer socket from the steering knuckle. Refer to Exploded View.
Remove the nut and bolt from the lower ball joint. Separate the transverse link from the steering knuckle. Refer to Exploded View.
CAUTION:
Do not reuse nut from lower ball joint.
Remove the rear torque rod and the rear torque rod bracket. Refer to Exploded View.
Separate the stabilizer connecting rod from the strut. Refer to Exploded View.
CAUTION:
Do not reuse stablizer connecting rod nut.
Set a suitable jack under front suspension member.
CAUTION:
Do not damage the front suspension member with the suitable jack.
Note: 
Secure radiator in place prior to removing the front suspension member to prevent radiator from falling.
Remove the bolts and the member stay (LH/RH).
Remove the front suspension member bolts.
Gradually lower the suitable jack to remove the front suspension member from the Nissan Sentra vehicle.
CAUTION:
Make sure the front suspension member is stable when using the suitable jack.
If replacing the front suspension member, perform the following procedures:
-
Remove the steering gear. Refer to Removal and Installation.
-
Remove the transverse links. Refer to Removal and Installation.
-
Remove the stabilizer bar, the stabilizer clamps, and the stabilizer bushings. Refer to Removal and Installation.
Perform inspection after removal. Refer to Inspection.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Do not reuse the transverse link nuts.
-
Install the member stay bolts and the front suspension member bolts in the order shown.
: Nissan Sentra Vehicle front
Final tightening (Specified torque)
: 1-10
Bolts 1-4
160 N·m (16 kg–, 118 ft–lb)
Bolts 5-6
75 N·m, (7.7 kg–m, 55 ft–lb)
Bolts 7-10
62 N·m, (6.3 kg–m, 46 ft–lb)
-
Perform the final tightening of the nuts and bolts under unladen conditions with the tires on level ground.
-
Perform inspection after installation. Refer to Inspection.
Exploded View
Exploded View
1.
Front suspension member
2.
...
Inspection
Inspection
INSPECTION AFTER REMOVAL
Check the front suspension member for cracks,
wear or damage. Replace components if necessary.
INSPECTION AFTER INSTALLATION
Check the
wheel sensor ...
Other materials:
Structure and Operation
Sectional View
Sectional View
1.
3rd input gear
2.
3rd-4th synchronizer hub
assembly
...
General Specifications
General Specifications
Unit: mm (in)
Type of clutch control
Hydraulic
Recommended clutch fluid
Refer to Fluids and Lubricants.
...
Leak Test
Leak Test
CHECK REFRIGERANT LEAKAGE USING FLUORESCENT
LEAK DETECTION DYE
Install a
fender cover (1).
Wear UV
safety goggles (2) provided with refrigerant dye leak detection kit
(NI-43926).
Connect
power cable (4) of UV lamp (6) to positive and negative terminal ...
