Nissan Sentra manuals

Toyota Camry Owner's Manual (2023): Refueling

Opening the fuel tank cap

Perform the following steps to open the fuel tank cap:

Before refueling the vehicle

■Fuel tank opening for unleaded gasoline

To help prevent incorrect fueling, your vehicle has a fuel tank opening that only accommodates the special nozzle on unleaded fuel pumps.

■If the malfunction indicator lamp illuminates

The malfunction indicator lamp may illuminate erroneously if refueling is performed repeatedly when the fuel tank is nearly full.

WARNING

■When refueling the vehicle

Observe the following precautions while refueling the vehicle. Failure to do so may result in death or serious injury.

■When refueling

Observe the following precautions to prevent fuel overflowing from the fuel tank:

NOTICE

■Refueling

Do not spill fuel during refueling.

Doing so may damage the vehicle, such as causing the emission control system to operate abnormally or damaging fuel system components or the vehicle's painted surface.

Opening the fuel tank cap

1. Press and hold the opener switch to open the fuel filler door.

Opening the fuel tank cap

2. Turn the fuel tank cap slowly to remove it and hang it on the back of the fuel filler door.

Opening the fuel tank cap

Closing the fuel tank cap

After refueling, turn the fuel tank cap until you hear a click. Once the cap is released, it will turn slightly in the opposite direction.

Opening the fuel tank cap

■If the fuel filler door cannot be opened

Remove the cover inside the trunk and pull the lever.

Opening the fuel tank cap

■When "Check Fuel Cap" is displayed on the multi-information display

The fuel tank cap may be unfastened or loose. Turn the engine switch off, check the cap and tighten it securely. If the message remains, wait a few seconds and then turn the engine switch off once again.

WARNING

■When replacing the fuel tank cap

Do not use anything but a genuine Toyota fuel tank cap designed for your vehicle. Doing so may cause a fire or other incident which may result in death or serious injury.

Changing the windshield wiper rest position/Lifting the windshield wipers
When the windshield wipers are not being used, they retract to below the hood. To enable the windshield wipers to be lifted when parking in cold conditions or when replacing a windshield wiper inser ...

Using the driving support systems
...

Other materials:

Sun visors
To set the visor in the forward position, flip it down. To set the visor in the side position, flip down, unhook, and swing it to the side. To use the side extender, place the visor in the side position, then slide it backward. Vanity mirrors Slide the cover to open. Vehicl ...

P0966 Pressure control solenoid B
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P0966 PC SOLENOID B (Pressure Control Solenoid B Control Circuit Low) The primary pressure solenoid valve current is 200 mA or less ...

1144 Incomplete steering angle sensor adjustment
DTC Logic Dtc detection logic Dtc Display item Malfunction detected condition Possible causes C1144 St ang sen signal When neutral position adjustment of steering angle sensor is not complete. Harness or connector Steering angle sensor Abs actu ...

© 2014-2022 Copyright www.nisentra.com