Component Function Check

Component Function Check

1. CHECK COMBINATION METER INPUT SIGNAL

   1. CONSULT

      1. Select “PKB SW” in “Data Monitor” mode of “METER/M&A”.

      2. Check that the function operates normally according to the following conditions:

         Monitor item	Condition	Status
         PKB SW	When parking brake is applied	ON
         	When parking brake is released	OFF

   Is the inspection result normal?

   YES >>

   Inspection End.

   NO >>

   Refer to Diagnosis Procedure.

Diagnosis Procedure

Diagnosis Procedure

1. CHECK PARKING BRAKE SWITCH SIGNAL CIRCUIT

   1. 1. Ignition switch OFF.

      2. Disconnect combination meter harness connector and parking brake switch harness connector.

      3. Check continuity between combination meter harness connector and parking brake switch harness connector.

         With M/T

         Combination meter		Parking brake switch		Continuity
         Connector	Terminal	Connector	Terminal
         M24	14	M130	1	Yes

         With CVT

         Combination meter		Parking brake switch		Continuity
         Connector	Terminal	Connector	Terminal
         M24	14	E80	1	Yes

      4. Check continuity between combination meter harness connector and ground.

         Combination meter		—	Continuity
         Connector	Terminal
         M24	14	Ground	No

   Is the inspection result normal?

   YES>>

   Inspection End.

   NO>>

   Repair or replace harness or connector.

Component Inspection

Component Inspection

1. CHECK PARKING BRAKE SWITCH

   1. Check continuity between parking brake switch terminal and switch case ground.

      Component	Terminal	Condition	Continuity
      Parking brake switch	1	Parking brake applied	Yes
      		Parking brake released	No

   Is the inspection result normal?

   YES>>

   Inspection End.

   NO>>

   Replace parking brake switch. Refer to Removal and Installation (hand lever with rear disc brakes) or Removal and Installation (foot pedal with rear disc brakes).