Nissan Sentra B18 (2020-2025) Service Manual: P1226 Tp Sensor

Nissan Sentra B18 (2020-2025) Service Manual / Engine / Work Procedure (After Replacing Electric Throttle Control Actuator) / Dtc/circuit Diagnosis / P1226 Tp Sensor

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P1226	CTP LEARNING-B1 (Closed throttle position learning bank 1)	Diagnosis condition	Ignition switch ON
		Signal (terminal)	Electric throttle control actuator signal
		Threshold	Closed throttle position learning is not performed successfully, repeatedly
		Diagnosis delay time	—

POSSIBLE CAUSE

Electric throttle control actuator (TP sensor 1 and 2)

FAIL-SAFE

Not applicable

Confirmation Procedure

Confirmation Procedure

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 10 V at idle.

>>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON.
4. Repeat steps 2 and 3 for 32 times.
5. Check 1st trip DTC.
Is 1st trip DTC detected?
YES >>
Proceed to DTC Diagnosis Procedure.
NO-1 >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2 >>
Confirmation after repair: INSPECTION END

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

CHECK ELECTRIC THROTTLE CONTROL ACTUATOR VISUALLY
1. Turn ignition switch OFF.
2. Remove the intake air duct. Refer to Removal and Installation.
3. Check if foreign matter is caught between the throttle valve and the housing
Is the inspection result normal?
YES >>
GO TO 2.
NO >>
Remove the foreign matter and clean the electric throttle control actuator inside, then perform throttle valve closed position learning. Refer to Work Procedure.
REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR

Replace electric throttle control actuator. Refer to Removal and Installation.

>>
INSPECTION END

P1225 Tp Sensor

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble ...

P1526 Vehicle Speed Sensor

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble ...

Other materials:

Rearview mirror (if so equipped)
The night position 1 reduces glare from the headlights of vehicles behind you at night. Use the day position 2 when driving in daylight hours. WARNINGUse the night position only when necessary, because it reduces rear view clarity. ...

Active Grille Shutter System
Component Parts Location Component Parts Location A. Behind front bumper fascia No. Com ...

Front disc brake
BRAKE PAD BRAKE PAD : Exploded View Cylinder body Inner shim cover Inner shim Inner pad (with pad wear sensor) Pad retainer Torque member Outer pad Outer shim Outer shim cover Molykote AS880N Molykote 7439 BRAKE PAD : Removal and Installation REMOVAL WARNING: C ...