Air conditioning controls
â– Adjusting the temperature setting
To adjust the temperature setting, turn
clockwise to
increase the temperature and counterclockwise to decrease the
temperature.
If is not pressed, the system
will blow ambient temperature air or
heated air.
â– Fan speed setting
To adjust the fan speed, turn
clockwise to increase the fan
speed and counterclockwise to decrease the fan speed.
Turning the dial to "OFF" turns off the fan.
â– Change the airflow mode
To change the airflow mode,
press
or
.
Other functions
â– Switching between outside air and recirculated air modes
Press .
The mode switches between outside air mode (indicator off) and recirculated
air mode (indicator on) each time
is pressed.
â– Defogging the windshield
Defoggers are used to defog the windshield and front side windows.
1. Press .
If the recirculated air mode is used, it will automatically switch to the outside air mode.
2. Perform the following operations accordingly:
To defog the windshield and the side windows early, turn the air flow and temperature up.
â– Defogging the rear window and outside rear view mirrors
Vehicles without outside rear view mirror defoggers
A defogger is used to defog the rear window.
Press .
The defogger will automatically turn off after a period of time.
Vehicles with outside rear view mirror defoggers
Defoggers are used to defog the rear window, and to remove raindrops, dew and frost from the outside rear view mirrors.
Press .
The defoggers will automatically turn off after a period of time.
P0130 A/F Sensor 1
DTC Logic
DTC DETECTION LOGIC
To judge the malfunction, the diagnosis checks that the A/F signal computed
by ECM from the A/F sensor 1
signal fluctuates according to fuel feedback control.
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possi ...
U1010 Control unit (CAN)
Description
Initial diagnosis of ABS actuator and electric unit (control
unit)
DTC Logic
DTC DETECTION LOGIC
DTC
Items
(CONSULT screen terms)
DTC detection condition
Possible cause
U1010
CONTROL UNIT (CAN)
When detecting error during the initial diagnosis
...
Transaxle side
TRANSAXLE SIDE : Removal and Installation
Remove boot after drive shaft is removed from the vehicle.
For drive shaft removal and installation, follow the instructions bellow.
6M/T: Refer to FAX-18, "6M/T : Removal and Installation (LH)".
Except 6M/T: Refer to FAX-26, "EXCEPT ...