Nissan Sentra manuals

Toyota Camry Owner's Manual (2023): Fuel pump shut off system

To minimize the risk of fuel leakage when the engine stalls or when an airbag inflates upon collision, the fuel pump shut off system stops the supply of fuel to the engine.

Follow the procedure below to restart the engine after the system is activated.

Vehicles without a smart key system

1. Turn the engine switch to the "ACC" or "LOCK" position.

2. Restart the engine.

Vehicles with a smart key system

1. Turn the engine switch off.

2. Restart the engine.

NOTICE

â– Before starting the engine

Inspect the ground under the vehicle.

If you find that fuel has leaked onto the ground, the fuel system has been damaged and is in need of repair. Do not restart the engine.

If you think something is wrong
If you notice any of the following symptoms, your vehicle probably needs adjustment or repair. Contact your Toyota dealer as soon as possible. Visible symptoms Fluid leaks under the vehicle. ...

If a warning light turns on or a warning buzzer sounds
Calmly perform the following actions if any of the warning lights comes on or flashes. If a light comes on or flashes, but then goes off, this does not necessarily indicate a malfunction in the sys ...

Other materials:

Removal and installation
Generator Exploded view Thermostat housing Generator bolt (upper) Generator bolt (lower) Generator B” terminal harness “B” terminal nut Generator harness connector Front Removal and installation Note: When removing components such as hoses,tubes\lines,etc,ca ...

Dynamic radar cruise control with full-speed range
Summary of functions In vehicle-to-vehicle distance control mode, the vehicle automatically accelerates, decelerates and stops to match the speed changes of the preceding vehicle even if the accelerator pedal is not depressed. In constant speed control mode, the vehicle runs at a fixed speed. ...

Turn signal lamp circuit
Description The bcm monitors inputs from the combination switch to determine when to activate the turn signals. The bcm outputs voltage direction to the left and right turn signals during turn signal operation or both during hazard warning operation. The bcm sends a turn signal indicator req ...

© 2014-2023 Copyright www.nisentra.com